In order to solve the problem of MOS transistor heating, it is necessary to accurately determine whether it is caused by the above reasons, and more importantly, to correctly test the power loss of the switching transistor in order to identify the problem and find the key points for improvement.
Categories：Product knowledge Date：2024-11-07 Hits：449 View »
The full name of MOS in English is MOSFET, where the suffix FET stands for Field Effect Transistor.
Categories：Product knowledge Date：2024-11-07 Hits：496 View »
Stability refers to the degree to which the parameters of an inductor coil change with environmental conditions
Categories：Product knowledge Date：2024-11-07 Hits：390 View »
When using neon glow bulbs, the following precautions should be taken
Categories：Product knowledge Date：2024-11-07 Hits：400 View »
The resistance value of the resistor should be calculated according to the design, and standard resistance series resistors should be preferred
Categories：Product knowledge Date：2024-11-07 Hits：372 View »
1. Sudden increase in power supply voltage. There are many reasons that can cause a sudden increase in the voltage of the power supply, such as quality issues with the power supply or improper use by the user.
Categories：Product knowledge Date：2024-11-07 Hits：456 View »
The identification of the positive and negative terminals of a surface mount diode is usually done by observing the markings on the diode casing. When the markings on the casing are severely worn, a multimeter with an ohm range can be used for identification.
Categories：Product knowledge Date：2024-10-30 Hits：468 View »
ESD electrostatic diode, also known as ESD protection diode, is a commonly used electrostatic protection device. It is mainly used to protect electronic devices from damage caused by electrostatic discharge
Categories：Product knowledge Date：2024-10-30 Hits：434 View »
Transistors and diodes are common electronic components that play important roles in circuits. A transistor has three pins, namely base, emitter, and collector, while a diode only has two pins, namely positive (anode) and negative (cathode)
Categories：Product knowledge Date：2024-10-30 Hits：375 View »
The most basic form of processing analog signals is amplification. In production practice and scientific experiments, analog signals obtained from sensors are usually very weak and can only be further processed after amplification or given sufficient energy to drive actuators and complete specific tasks
Categories：Product knowledge Date：2024-10-30 Hits：416 View »
